Quote:
Originally Posted by BORMAC
But it is tight though isn't it. Im not using the little glue on C/F pieces as I use my batteries for other cars also. I need to work out a way for the pack to not slide around allowing for those wires to come in contact with the pulleys. I have put foam padding on my battery strap already and it holds the pack in nicely but a good shunt could make it shift and begin rubbing the wires without me knowing. This is my only dilemma with this car-
|
This is what i did. The rear of the servo is flushed with the bulkhead, together with the rx, esc forming a straight line. Then, upon inserting the lipo, it is 'pushed' against the electronics, leaving a lil gap between the lipo n the undertray. A battery foam gets the job done. No worrying about lateral movement whilst ensuring the weight is focused pretty much to the center. Hope it helps
Oh, and pls disregard the battery wires, its suppose to be facing in
