Quote:
Originally Posted by woOdy
Today was better than Worksop.
front:- Light green springs
2b pistons
45 wt AE oil
middle on tower
inner on wish bone
30' caster
wish bones just below level
Rear:- Silver springs
2b pistons
35 wt AE oil
inner on tower
inner on wish bone
medium wheel base
cells rear
drive shafts level
13' on rear wing with 2mm on dam
Brass bulk head
Upside down front pivot block on anti squat and 1mm washer under rear.
I am running the Worlds wish bones with drive shafts and hubs but not tower or shocks.
Camber links, front:- middle on tower with 0 washers and inner on caster block.
rear:- middle on tower and outer on hub with 5mm washer on outer ball stud and 0 on inner stud.
|
Cheers!
Quite different to what I ran at the weekend but gives some food for thought!
Stu, can you confirm to me about the pistons. From all the posts Ive read I gathered that 2Bs were middle and that 2cs were the ones with the smallest holes ie the hardest but when Ive put 2cs in the front the front is much softer. I measured the diameter of the holes and the 2cs are larger than the 2bs! Is that correct with what you know? Its the same with Sharpys aswell. His front end is always so soft.
