Quote:
Originally Posted by Fred79
Fabs:
When I try to put on some 30mm foam tyres on the rear they touch the ball link at the end of the supension shaft.
What do you guys do to make them fit?
Do you flip the wishbone arond and move the suspension lin 1 hole further in on the arm?
( if you flip it you will se there are 2 holes instead of one)
What to do???
And will those changes effect handling?
|
I only ran foams once in my life and to be honest i didn't like it. They require a totally different setup to rubber and as sosidge said, there isn't much difference in lap times, and you have to true them and they chunk etc...
My advice is, if you're a newbie, stick to rubber, pick my setup and run a reasonably slow motor to start with, if you want to run 5-cell then i suggest a 6.5T as this is equivalent in power to a good 19T.