Quote:
Originally Posted by Spoolio
Offhand does anybody know what bearing sizes fit these wheels? The wheel part ref is JCAF and they are a 5-spoke design. The bearings my RC10 came with (fitted into the original 3 piece wheels) have an OD that is too big although they do fit B4 wheels nicely.
|
Hi, are these the rims? These are the JC racing ones - very happy with them so far.
Do note, however, that the offset is a bit different to those of your original wheels, and that the wheel wil run a bit closer to your a-arm than it had done. It's not so serious as to cause interference with most tyres, but if you have the stock arms and try to run a wide tyre like the proline wide ribs - you will have probs.
Yes, your old bearing is 3/16" ID x 5/16" OD with a 3/8" flange. The ones you need are 3/16" ID x 3/8" OD with no flange, as Richard pointed out.
I ran into this same problem when I was getting these new wheels for the RC10... If you'd like, I have four brand new bearings that would help you out. PM me if you're intersted.
Cheers,
Ty
