Bungleaio - nope. If you look up on this thread you will see the discussion. The reason I included that photo was to highlight my point. There is about 15 mm gap between top of the cell and the top deck, so it's going to be awkward with TrackPower cells.
Certainly not impossible, but would mean soldering the connectors at right angle, then maybe plugging it in before the slotting cell in car.
However, the two holes on the top deck I think is perhaps where the aerial is mounted on the NiMH version (I need to check manual), so it should be clear on the LiPo (aerial mounts near receiver on LiPo, but rear left of car on NiMH). I am therefore tempted to enlarge the hole in the topdeck so I can thread the power line through.
__________________
Jason Moller
|