have just done this myself as needed a new case for mine. there are 2 screws inside which make the change very difficult. i personally prized the motors section out very slowly which then gave me access to the screws on the other side but with hindsight i would of desoldered the 3 legs of the rotory switch first as this would of made the whole opperation a lot easier as then you can take the motor and board out easily and get to the 2 mentioned screws. if ya have any questions feel free to pm me
__________________
Nathan Ralls HPI, Custom Blitz, www.piraterc.com mr-o foams
woop woop racing officialy keeping team toe out inline 
|