[Northy]

A couple of people asked for my set-up at Southport because they said the car look very planted, so here it is:

front

springs blue (no compreision spring) 5 1/2 turn in older style
oil 30wt losi
piston kit (1 hole 1 groove) with hole drilled out to Losi Orange and with standard rebound valve
rocker mounted upside down
pushrod under rocker
droop 37mm
std front arms with 0 washer behind wishbone
cone washer replaced with 2 x 1mm washers
no roll bar
ride height 18 mm (driveshafts just below level)
front wing cut so it is as large as possible
0 toe out
-1 degree camber

rear

springs blue and compresion spring 5 1/2 turn in older style
oil 37.5 losi
piston kit (1 hole 1 groove) with hole drilled out to Losi Orange
lower hole on shock mount
no roll bar
std wheelbase
ride height 24mm
1.5mm rear block (reduces on power steering)
large rear wing with full gurney
3 degree toe in per side
-1 degrees of camber
rear uprite in upper hole

shumacher yellow minispikes with outside row cut off rear and inner and outer cut off front

5.5R nosram 14mm sintered rotor
18/72
nosram istc
speedo settings 2/2/2/2.