[Chrislong]

Hey Russ,
Check the axle, where the pin rubs on the slot of the ball - if that makes sense. If that edge is not flat, then you ought to buy the full wishbone kit mate.

if you just need bones, then the ones you have can be redrilled, although they do not spin as well due to the pivot points not alligning at both ends. You will need a jig to do this, so if you don't know anyone that has one - you'll need to buy a jig.

The driveshaft you broke at Belgium was an alloy one mate, I remember it as I picked it up for you. If you want a longer life bone, go for steel.

Chris