There is your problem!!!!!!!!!!!
I NEVER run in the inner wishbone holes front or rear any more for exactly the reasons you are experiencing!!!
Run outer hole in the front and middle hole in the rear wishbones.
Shock lengths 20mm between cartridge base and shock eyelet front and rear shocks (will check for sure but I believe it is 28mm for the same measurement). To achieve this you either need to run the 54mm shock shafts or the normal 50mm ones with the eyelet unscrewed a few turns.
You will need to run in the very outer most hole on the new Atomic Carbon shock tower and you might find that the car is more consistent running the rear link outer hole on the hub (between 2 and 4mm under ball stud ..... normally 2mm) and with no washers under the inner ball stud.
If you want to make the rear feel more alive then try 35wt oil which slows the transistion a little.
Set ride height so that the rear shafts are just below level (inner end lower than outer end) and the front end so at rest it is 1-2mm lower than the rear.
See if that helps
Cells forward at all times!
|