[501X Driver]

Good Feed back so far- I have tried alot of these-
sosidge- Correct, I don't want to go any larger and would like to get rid of them. The 2 corners that I need to carry the speed in are 95% smooth. The rest of the track and a lot of the straight leading to the first corner has most of the bumps.

chrispattenson- I do not have any spacers under the inner camber blocks. They are short in the rear and long in the front. The rear has 3mm spacer on the outside to raise that end. There aren't any big jumps, it is setup where you can easly land on the down side. The limiters will be a good test. But I need to not shorten to much because of the bumps.

jimmy- I will try laying the shocks down some. I have been moving the bottoms out and in to see what that did but didn't seem to do much.
I will try this before putting any spacers inside the shock.

richard- the tapers pins up front have the least amount of traction and the square fuzzie normally doen't work on this dirt, no one runs them and I have the hardest ProLine foam (dark grey). If I run the Double D's, Evil Twins, Holeshots I have to use brake to really slow down in the corners.


A lot of the 4wd and some mod buggies are having this problem.
We are guessing that the track just has alot of traction, but there has to be some way to use it and not waste it.

Thanks for the ideas so far, don't stop I need more.
Thanks again.

PS- this Team Azarashi body is the bomb. It seems to make the car handle better and feels like it has much more down force