I run on a hard packed dirt surface that stays moist. Little dust.
It has a lot of small holes requiring us to run a soft setup.
So I am running #4 and 32 wt oil in front and #3 and 27 wt oil in the rear.
I am running the largest Kit sway bar in the front and a custom .063 bar in the rear. I think the factory large bar is .056 So I am running a lot of bar I think.
But it still traction rolls if I don't reduce my speed below what I think would be normal. I run Taper Pins up front and Square Fuzzies in the front. If I use a tire with with good traction I roll at a slow speed.
Do I need to run more sway bar?
Do I need to go to a Larger Piston and Heavier Oil?
Smaller Piston and Lighter Oil?
I Don't Have a Lot of Practice Time to Try Different Setups.
So if anyone knows what direction I should start it would be very helpful.
Other wise I am going to just change and test durning the race.