Right then
- built and now fine tuning a few bits to RogerM's set up as a good starter for the weekend coming. (Our track - outdoor, grass, bumpy to very bumpy, jumps and high grip.)
Front
Q1 - I can't quite read location of ball stud on front Hub on the set up sheet posted. Is it toward the front or back?
Q2 - Axle height spacer - is this the location of the spacer itself, or the result of the location of the spacer (I hope that makes sense)
Rear
Q3 - Hub spacing. It states back. Do you put the spacers at the back - therefore Short wheel base, or is it the Hub at the back therefore Long Wheel base?
General
Q4 - I have followed everything, but the ride height is pretty high - i.e I have unwound the rear shock adjusters all the way and only now are the wishbones just showing level. On the Front the same and have the drives showing level (slightly smiley wishbones) I notice 3.75mm on the ride height for the front? Where's that measurment from and too?
Phew - that's it!
