Had a look at the instructions that came with it, thought I would put it back to factory settings and try again.
BUT
It says:
High flow rate - screw fully in and then out 3.5 turns
Low flow rate - screw fully in and then out 5 turns
Now this may seem like a stupid question, what do they mean by a turn?
Is it a full 360, or just 180?
The reason I ask is that if I turn the low end screw out by 5 * 360 turns it seems too far, its well out of the casing. The top end is not as bad, whereas if I use 180 as a turn they look better.
|