Quote:
Originally Posted by Cockerill
The hex goes through both bearings, and then the spacer goes on. The screw then goes through the hex from the inside so you have a thread for the nut.
|
When I put the axle in it does not reach the inner bearing at all. I have done some measuring and the stub axle itself after the hex measures 11.4mm. The distance from the outside of inner bearing to the end of the stub when fully inserted is 3.6mm. When I measure from the where the hex sits to where the spacer should touch the inside bearing I get 15mm.
The packet that contained the hex axle parts came in was yellow so I am wondering if the newer coloured packs contained updated parts with the same part number either that or I have the wrong spindle and carrier. Does anyone have the titanium stub axles available as I have seen these and they are longer than the one I have.