Quote:
Originally Posted by d16dcoe45
If you run the 36t pullies with the 18 tooth center pulley the belts will be too long. Even if they fit, it would leave you with a 2.00:1 drive ratio and you would have to run a smaller pinion to compensate. Also, if you only run one 36t pulley--the end you run it on will be overdriven--can be good and bad depending on how you drive. Also, I believe the 36t pulley only takes 8 diff balls.
Look hard on your shafts, I bet the gold looks very light and silvery. I would be surprised if you had zero loss of the nitride coating.
|
What about a 40 tooth TC5 pulley?
Yes I dremeled some plastic to get it to fit properly.
And those 3mm tugsten diff balls(or the stock diff balls) will fit also.
Wont be til next week before I have them though...backordered..
