Quote:
Originally Posted by CAClark
Hey guys, yet again I am stumped by what is I'm sure something quite obvious
I have a set of aeration dampers, but the instructions have got me stumped. Building the pistons and rods was fine, but cylinder end where the little red o-rings go has got me, because the instructions show a red o-ring, then a black spacer, then 2 4x0.1 shims, another black spacer, and then another o-ring. That means I should have 8 of those there shims, but there are not 8 of any component other then the black spacers. I have 4 white nylon spacers, and 5 metal shims (which are used to assemble the pistons as far as I made out).
This then compounded by there being upper and lower rod guides... the upper being shown sandwiched above the cylinder end ( the bottom seal cartridge bit), but the lower one seems to be shown effectively in the same place.
I'm sure it's not supposed to be difficult, and I am probably being dim, but some help would be well appreciated about now.
|
I was also confused by this;
The White nylon spaces are the rod guides and go first in the cartridge end of the shock bodies (the hot looking ones go into the rears). The 0.1 shims are the metal shims, and from memory these go into the cartridge bit.
I'll have a look when I get home and let you know exactly how I built mine.
I ran the Durga with these shocks on Sunday and I was very very impressed!