Hey guys, yet again I am stumped by what is I'm sure something quite obvious
I have a set of aeration dampers, but the instructions have got me stumped. Building the pistons and rods was fine, but cylinder end where the little red o-rings go has got me, because the instructions show a red o-ring, then a black spacer, then 2 4x0.1 shims, another black spacer, and then another o-ring. That means I should have 8 of those there shims, but there are not 8 of any component other then the black spacers. I have 4 white nylon spacers, and 5 metal shims (which are used to assemble the pistons as far as I made out).
This then compounded by there being upper and lower rod guides... the upper being shown sandwiched above the cylinder end ( the bottom seal cartridge bit), but the lower one seems to be shown effectively in the same place.
I'm sure it's not supposed to be difficult, and I am probably being dim, but some help would be well appreciated about now.