I ran my car last week with Tebo's setup and new set of double dees tires. They car was great. I gained a lot of rear traction. It didn't spin out anymore.
One problem I have now is my front arms kept on breaking. I think it's because of no servo saver (anyone??). They normally break during a hard landing from big jumps.....when the car lands a little bit off certer. Do you guys break the front arms frequestly too?
Now trying to experiment with running the tamiya 501x front arms. Can dremel the arm to fit the front bulk head...the easy part. Only problem is fitting in the hinge pins. Need to drill a bigger hole on the hinge pin brace. I hope this cure my front arm from breaking apart all the time. Any other ideas?
