[Chrislong]

It looks very good.

For chassis bracing, I would go for triangulation. A piece on each side of the chassis, from mid way along the cells and going back and upwards mounted high on the tower - triangulation is great for reducing flex. But remember to keep it light - use some Carbon!

Also, I would consider raising the sides of the chassis front to back - carbon? it could be bolted on from the inside with countersunk screws so everything wil still fit.

Also, finally. With mounting those arms you have opened up the possibilities for the rear end, why don't you take the wheels off, widen the track to the point where you will be able to use B4/Losi rear wheels and have the correct total width, should be possible with B4 rear driveshafts.

Id name it the = ognarud