Quote:
Originally Posted by myzislow
LOL I'm running the balck 104 spur and an 18t pinion with standard X factory gearing.
|
I asuume you mean std pulleys all round? In which case you need some belt skip. The drive pulley (on the slipper shaft) I'm afraid isn't perfectly round which promotes some skip. If there is no skip on a std pulley the belt tension must be very tight.
The best solution is to change out the drive pullet for the front pulley on the rear belt on the xx4 (needs slight shimming). This is perfectly round and makes setting a better, more accurate belt tension.
http://www.one-ten-rcforums.com/4wdr...ic.php?id=1540