Quote:
|
Originally Posted by Marco
Hi Jason,
i would take a 16t pinion for the 10x1 motor. try a 18t pinion for the 12x1 motor.
but it's hard to tell since the internal gear-ratio isent mentioned in the instruction-manual.
greets from switzerland
Marco
|
Hi Marco,
I have counted the internal gear-ratio that is 33/16=2.0675
I'm really afraid of over heat for i used to have lots of this problem when i was using the XXX4G+
It's not easy for me to buy any pinion smaller than 18T. Maybe i'll try the 17T for 12X1 first.
Thanks a lot~
谢谢(Thank u in chinese
)
Jason