Ok, just built up the new slipper unit, went together very well. So im just after any tips on its use.
I built it to instruction and set the spring to the 6.5mm gap setting. This a good setting in practice?
also didn't use any thread lock anywhere apart from on the grub screw, should I have?
and lastly, how do adjust front and rear slip independently, or does it just mean it will automatically slip independently.
it looks good cant wait to test it
While im here, when i removed the old unit i noticed there was a fine white powder covering the spur, could this be from slipper pads or pinion? both have been recently new so i cant tell
cheers
dan