ESC help
 

i have just installed the electrics in my dex410r and have a problem.

i have calibrated the esc (speed passion gt 2.0) following the instructions which is pretty simple and paired this to a speed passion ultra sportsman 13.5T motor and charged the lipos for the first time and hit a snag.

when i use the throttle the esc is fine with the buggy off the floor but as soon as i load it by placing the buggy on the floor the green light flashes, this according to the instructuons is a problem with the sensor cable, but seeing as the esc and motor are brand new i find this hard to believe?

anyone have an idea why this happens? sorry if this is a bit vague but i am new to this and don't want to mess it up or cause any issues with my electrics.

thanks

Have you another sensor cable to try or just make sure the cable is fully home at both ends. Have you down loaded soft wear on to your program box/ esc.If /when you do always down load twice + always re-calibrate your hand set after changing soft wear ,and by the way never rev the car with no load on it .With these ecs you can blow the motor

..... and double check the ABC orientation of the wiring too !

no spare sensor cable, both ends fully seated as far as i can tell, i havnt downloaded any software, its as it was when it came out the box?:confused:

as for the ABC yep, they are in the right order. :)