Help with core-rc code fhss
 

I have recently bought this tramsmitter set but cannot figure out what is wrong with the throttle adjustment, I have the same problem in both cars so it cant be the speedo, I'm currently running a dex210 with hobbywing xerun brushless and the other a 12th with lrp v7.1 brushed.

The problem is full throttle is reached after approx 2 thirds of stick travel, thus the top third of travel does nothing and means throttle control is far more difficult than it needs to be,
I'm sure they must be a simple fix for this but I'm too simple to work it out! :eh?:
Anyone know whats up? :confused:

Forgot to add, brake side is ok :confused:

Alan. Have you tried to setup either car/speedo with the new transmitter? ie neutral, full throttle, and brake.

I had the same issue, reset the EPA, recalibrated the controller and ESC and it was sorted.

Hi,

Yes both cars, and now just tested it on vrc, all the same. It actually seems closer to halfway up the range of movement that full throttle is engaged :(

Hi, I have reset the transmitter back to factory, if i press the bind button i get alternating green and red flashes?? Manual says I should get solid green.
Once the bind button is released I get the solid green and the problem is still there :confused:

Can anyone post the correct binding proceedure as I suspect this might be my problem, the manual poor does English it in read. :eh?:

If the tx and rx are communicating, then it doesn't sound like a binding problem.

Yes they do communicate, I have just discovered that also the left turn is similar but not as bad... the last bit of travel on the stick does nothing, I've spent a good couple of hours now trying to sort it and searching online and come up with nothing, think its going back tomorrow :(

Have you tried a complete reset of the transmitter; it is number 18 or 19 in the menu if I remember correctly.
Also make sure that the right top switch (i think it is called Throttle hold) is up and not down.

Hi, thanks for the reply, I have reset it twice now and yea the stick is up, when down the default throttle hold is neutral.