Speed Passion Motor Problems
 

Hi,

Ive got a sp motor which will only work when you push it. i have changed the connection shields and changed the sensor wire. when it stops the motor wont run again unless you push it again.


Thanks

does the motor work fine senseless?

Its not a sensorless motor its a v3.

sent u a pm dude

Are the 3 plugs in fully and not able to wiggle?

personal i think its the internal board in the motor

yeah they can move allitle.

how can i change or fix this

Im not saying for def that this will fix it but i had one that did the same thing (ish)

Here is the part number SPSB218

thanks ill give that a try.

Ive got my friends 7.5 to work with my sensor borard so i can run it now :D

You can get the motor tester from Schumacher. Tom was testing a motor last night with one, simple but effective.

The motors probably a shorting out.

I had a SP motor that wouldn't move from a standstill, but if you gave it a nudge and didn't let it stop it would run fine.

Turned out to be 1 of the phases on the speedo (SP GT2.0 LPF) had gone down. It was replaced by Schumacher under warranty.

Ive been incontact with schumacher and im going to ask if i can send my motor in to be tested to get it sorted out

yeah but if i tp or crash then it wont move. im just gunna send it too schumacher to be fixed.

Needing a nudge is almost always the speedo. Have you tried another motor on it?

I had a SPEC Novak Speed Controller I intended to use for the wet car last year, I had the issues where the car would need a nudge to make it move..I thought this may have been the motor. As it wasn't a good quality brushless motor that was paired with it originally. Soldered a GM10.5 on and gave it a test run, accelerated fine...hit the brakes and the speedo went up in a huge puff of smoke, which in turn melted the top PCB to the lower one.