My new Mid 410 by Rebelrc
 

As title says

Nice.
Just one question...
Is there enough room to get a sensor wire into the motor?

Yes
None of those internals are fixed in just sitting there for photo

Just thought it looked a little tight at the back..

THat looks tight in the rear and doesn't look like you can move the rear lipo back further. Isn't there motors that the sensor cable comes out the side?

Thunderpower and Turnigy from memory but those motors may then be longer as well.

Don't really want to build the car around a specific motor, makes things a little limited

Nice work Rebel

Another layout

how are you going to procure forward motion with that? i'd like to see the center drive connection your going to have to design for this.

maybe like the tamiya?

5 Djoint kits for each shaft :D

Why:confused::confused::confused:

Vampire Racing motors has the sensorcable attached to the side.

http://www.sven-rudig.com/vampire/images/TYPE_AB+_3.jpg

the rear shaft looks close to the motor in your 2nd layout

Why ask why?
Surely it obvious.

Also cheers guys but sensor wire is no problem

how are you going to get the driveshats to the slipper with this wats wrong with it standard

Waste of time.

Shirley it`s obvious ( if it ain`t broke , Dont fix it ):p
No point in sending me pms calling me a pleb for stating the obvious !!!

BELTDRIVE INERTIA ADVATAGE WITH SHAFT RELIABILITY AND AGGRESION!
For the UN believers.

Yes cause that's how we as the human race progress.
Don't improve anything!

How was that calling you a plebb?
I will post my un edited pm.

I like that idea!
just show us how you go on =)

Awesome!
Can't wait to see the crown gear mid motor 410!
Maybe with a center diff?