Best countersunk screws
 

After some decent 2mm countersunk screws.

Had some Swiss cheese ones recently, so recommendations?

Try www.modelfixings.co.uk you need to get the high tensile steel ones as they should be grade 10.9 or 12.9 which is high tensile. Stay clear of stainless steel as they are too soft, A2 is equivalent to approx grade 4 and A4 same as 8.8.

http://www.rc-screws.co.uk/ :thumbsup:

I bought a load of different sizes from Kev at Inside Line. I think they are only stainless steel, but touch wood I have never had any problems with them. :thumbsup:

Xray screw are really good quality but the price really shows, I'm not sure if they still do but they used to sell them in packs available from teamxray.co.uk.

I'm sure there are plenty of other good ones out there too, but generally speaking you will get what you pay for.

good luck

+1 never had a problem with mine :thumbsup:

Screws
 

http://shop.cpdracing.co.uk/index.ph...ort=20a&page=3
High tensile screws!!

Can recommend model fixings....all screws about 2mm will be a bit bendy though, or they just snap!

you wanting m3 screws with a 2mm hex or m2 screws which will be smaller hex

M3 2mm

i went to my local bolt suppliers bapp bolts, got shit loads for £20 of all lengths

www.screwz4rc.co.uk highly recommended.

You wont have a problem with Kyosho ones :)

+ 1 on Kyosho bolts, bought a few packs of these in my time, very good quality :)

Many thanks people, have now ordered what I'm after along with some new hex ends

+1 for Kyosho :)