X2C Rear mount
 

Ive had this mount made for my X2C finished off today. i am hoping to run it this friday at ribble vally. i only have a bad set of scales but the part is arround 60g, in the pic is the plastic kit one the AR ally and the brass one.

http://i42.photobucket.com/albums/e3...Crearmount.jpg

here is a pic of it on the car

http://i42.photobucket.com/albums/e3...rearmount2.jpg

anychance of making the pictures bigger? they are a little hard to see, unless that is just my pc?!

here is some bigger pics

http://i42.photobucket.com/albums/e3...1130-00138.jpg


http://i42.photobucket.com/albums/e3...1130-00139.jpg

Had one of these a while ago, never felt the need for it though, however that was outdoors...

I would like to know if anyone could make a similar rear mount in alloy, that is also tall enough to bolt the gearbox to.. currently i have spacer tubes between the top of the rear mount and gearbox case to support it as i use a flat shock tower bolted to the front of the mount.. ?

Me and Rob are working on some Dave. Just waiting for Rob to give me some measurements :thumbsup:.

wicked.. :thumbsup:

who did them for you?

The alloy one is an upgrade part from ansmann. The bras one was made by a friend of mine.


Ran the brass bunkhead last night and found that it is far to much on carpet as the high grip and the transisional weight makes the back of the car colaps in the mid part of the corner. I think it would work well on low grip and wet condisions. More testing soon.

here is a picture of what i mean :

http://i463.photobucket.com/albums/q...1/SDC10147.jpg