B44.1 steering jamming problem
 

If you look at the car from the front when I steer to to left the steering seems to get caught on the gearbox??? but is fine steering the other way have check all link arm lenghts and have tried the different spacers on the servo am using a savox 1251mg. I have only just built the car so any ideas welcome

make sure your steering rack ( the bit the ball joints fasten to on the steering posts) is the right way up, the outer part is deeper and the flat side should be to the top and the lumps to the bottom

have checked that all looks ok just seems rack goes further one way than the other and catches diff housing?

Can you post a picture?

Must be miss built as mine is nowhere near the gearbox. Loads of clearence. Not the ackerman is it?

i belive it is the ackerman when u turn to the left looking at front of car it jams when turning right load of clearence???

just been told got to set steering end points on tx just got to work out how to do it

Make sure servo horn is offset too as per instructions.

my brother had same problem, swap the caster blocks around, put the left one on righ, right on left, that sorted his.

Thanks for al the replys I had built it wrong:thumbdown: al sorted now