X4TE Top plate
 

has anyone got a picture or diagram of the top plate cut on x4te is it straight up the middle of the rear top plate so that its two strips.

Taz
you are better to post this in the Ansmann Section, not general race chat. You will get a better response.

Even though you took the time to post and say too put it in a different section yet you still run the car and couldn't answer him.

http://ar-uk.co.uk/product/Ansmann_R...R_Kit_id45291#

Hope this helps.

I haven't cut my top deck, and haven't seen one that has been done. I therefore don't want to give wrong advise. I have already sent a PM to Taz earlier telling him to ask Mossy who has experimented with the top deck, as he is the best person to comment.

And what use is your link Mr Wonderful? It's just a link to the car spec? I guess you didn't understand his question?

Taz - read this thread as i told you to earlier before you started another thread. The top deck is discussed here.
http://www.oople.com/forums/showthread.php?t=82917

But if you have Anmsann questions, post them in the Ansmann Section

At no point "Sir Usefull" did he state it was a non standard mod he was considering, Simply asking where its cut so I assumed he meant from the box, Which is enough reason to make my "Useless" link, Usefull.

Hope this picture helps. Its what both Si and I have done.

Thanks

Danny

x4te top plate
 

thanks Danny for the picture. there was no need for the hassle this caused i had already posted this on ansmann link with no results and also sent a private message to Mossy last week still waiting for reply i thought i would post it on the main site for more help and thanks to danny i got what i was after.if i thought posting my question on various sections was going to create greef then there no point using this site.

No harm done Taz.

whats the benefit of cutting the top deck ??

Gives the car more flex. Therefore generate more mechanical grip.

I think Mossy and Danny feel that the car is too stiff out of the box. :thumbsup: