ANSMANN TEAM DRIVERS
 

hi looking for ansmann team drivers have been selected as one of there drivers and i am looking for hints and tips for setting up an x4TE . first issue i have had is fitting lipos as they don't slide under top plate can anyone help:woot:

what lipos do you have for a start? are they brca legal? If so then they should fit ok. If you have ones that aren't a standard size then you may run into problems.

lipos
 

i have ansmann 5ooo saddle pack pre-wired the wires are hitting the top plate

Follow the link below to the ansmann section:
http://www.oople.com/forums/forumdisplay.php?f=81

You might have to dremal a little material out of the top plate to allow the wires some room. Might be a good idea to check the brca site to see if yor saddles are on the list.

if i remember right, they aren't brca legal and are very thick compared to legal saddles. They probably would struggle to fit under the battery straps.
the 4200 saddles are the thinner ones that fit in.

I would suggest dropping Woody a message stating the problem and see if you can exchange them for the 4200's. If you ordered them at the same time as the car I would have thought they might have mentioned that they aren't really compatible.

Im pretty sure the ans batts arnt BRCA legal.

lipos
 

cheers guys only have one set at the moment will check and get usable ones. not ran the car yet any useful tips look out for when running it out the box

have a look in the Ansmann section. there are build tips and set up tips in there.