DEX210 Wing - Where in stock?
 

When making the holes in the DEX210 wing I didn't measure and it turned out afterwards that the dimples on the wing were too far apart for fitting it onto the DEX210.

It will be a spare wing for my TRF201 as it does fit on that, but that means my DEX210 is now missing a rear wing. Is it in stock yet at a store based in Europe?

Get an LMR wing for it. Job done!

Yup much better wing, stock 210 wings are terrible.

Only downside to LMR - pig to cut..

Terrible?
Justification?

Had mine on since the oOple race.

I have a LMR Electra wing on mine, fits okay just a little thicker than normal wing so the plastic washers won't fit. I have mine with washers underneath though.

I may have just been unlucky but I landed badly and it tore off. No I hadn't drilled the holes too big.. First wing I have broken off in two years

Was going to put a 410 wing on, but picked up a wing from lee when he was at torch :)

more importantly when are the wheels going to be in shops:confused:

I have plenty of white front wheels going on the on the website tomorrow evening. Pm me if you want any.

cheers mate but fronts arent the problem for me its the rears any ideas if any other wheels fit

The durango pin drive rears fit if you use the cone washer and spacer from the 2010 410

CHEERS :)

That means the B44 and losi will fit as well right?

Yes, but the pin will need to be shortened, as the slot in the B44 wheels is smaller. From memory the b44 wheels are a different offset.

The LMR wing seems like a nice, chunky wing, but I'd like to keep my DEX210 stock for now. As for cutting the LMR wing, a Dremel does the job, right? :thumbsup: I always use a Dremel for my bodies, much more accurate if you don't try to cut through at warp speed :p