Post your dex210 videos here
 

I can't find many videos of these things running, so let's see them.

http://www.youtube.com/user/modelcar...g?feature=mhee

Would of been a quick run if it wasn't for all the mistakes!

what set up are you running?

Chris's setup is posted on the durango website under taplow.

I have changed the spacers on the inner camberlinks to 2mm since then and the rear toe to 3 degrees.

I can't get itt to open, I get file is damaged??
I could get Davids but not your Chris

http://img856.imageshack.us/img856/6001/unledlxu.jpg

Note: I have changed the spacers on the inner camberlinks to 2mm since then and the rear toe to 3 degrees.

thank you

I had a pretty close setup of Craig Collinson (think it is his) setup before, yours is quite different.

Anyway Im slowly testing and changing small things towards your set up, I found that changing from 2+2mm in the rear hubs to your 4mm in front of the hubb seemed to make it a bit lazy. Im going to swap back and test again, otherwise i did notice differences to the better while changing.

Thanks again nice work

Here is a little vid of me driving with the VBC slicks

Dammit, you left me in the vid, thought i asked you to photoshop me out :(


;)

Could you post a setup, goes over them big jumps very nicely, something mine doesnt....

Cheers

Im pretty close to David Poulters astro setup

nice vid Colin and good looking track layout with changes to surface pity only the 1 jump though!