Schumacher Wheels on X4TE
 

For those of you with a stack of pin drive wheels you wish to use

Parts required.

2x U3368 (schumacher part code)
2x 191000128 (ansmann part code)

Simply

1. Remove existing hex and pins.
2. Slide 3 of the shims onto the axle
3. Slide the schumacher wheel disspacers over the axle
4. Refit the drive pins.
5. Refit wheels.


Job's a good un

The shims are critical to prevent binding the spacers into the bearings.
The schumacher spacers have a raised edge which again reduce the chances of binding.

nice one Wayne. How's the offset compare?

Using my eye to judge it and having done each side separately so each side had differant wheels the off set is the same.

cool.
forgot to ask, was that both front and rear rims?

Yes same treatment to both ends, both rear and front are ok.