Help. CR2 buildup.
 

Hi Guys,
I have bought an aluminium chassis plate for an Atomic Carbon CR2 and I am trying to build it up.
Question
1) Is there a special front "Kick plate" that was part of the original kit or do I have to modify one from the donor buggy? If it is a special, where do I buy them from? Nortech only seem to sell complete kits and a few unrelated bits.

2) Why do I need an NT front bulkhead and not one from a CR. What is the difference?

3) Are the motor mounting plates with idle/reverse gear available or again, will I have to make one up? If so does anyone know a suitable idler gear to use.

Any help or suggestions much appreciated

JohnW

cr2 build up
 

Hi Matey the cr2 needs the xxx-nt front kick so it bolts to the front of the chassis it fits with four screws,the 4th idler gear is the standard losi idler and fits with a atomic carbon kit which very sadley they no longer make :( hope this helps anymore info pm me and i will help.

you need the xxx nt front end cuz this bolts to straight on to the alloy chassi where the cr one will not. the idler gear is the same as the one thats in the gear box you will need to drill a hole in to the motor plate and youl need a post and some bearings for the new idler gear to run on

Thanks guys . Fantastic. Will buy NT kick plate and get building.
JohnW