XXXCR 3 degree rear pivot blocks
 

hi there

im looking for 2 or 3, 3 degree rear pivot blocks for a XXXCR
or anyone know where to find?? link??

thanks

anyone got one to sell?? :confused:
this is urgent :cry:

have looked every were and as far as i can see they only do a 0 degree and a 2 degree
your talking about these right

i think i have 1 or two i can spur ill check which ones i have not sure if there 2 or 0 degree

3 degree is the toe in angle on both of these, the 0 and 2 refer to the antisquat (kick up) angle

Yea i made that mistake at first.

A

ha ha yeh well spotted didnt think about that

I only know since when we send one out to a customer they 9 out of 10 times they ring up and say they want the 3 degree one and we sent them the 0 (or 2) We had to clarify the spec many years ago for these parts (since they were first used on the back of the XXCR (XX not XXX))and have been used for some time now by Losi.

(A2112 and A2113 are the part no's - £3.95 each)

also fit in the xx4 if you cut out the bars joining em

Yep thats right, which is the same as part number A2213 (rear 3 degree blocks - XX4) where Losi cut both of them for you (well machined them) and you got both halves of a 2 degree and both halves of a 0 degree in the pack (they also lightly cut away a section in the middle of each block for extra clearance of the diff outdrive which was closer/lower to the block than on the 2wd it was first meant for) sells for around £8/9 if my memory isnt letting me down.
These were used with the 3 degree rear brace on the worlds version of the XX4 (with inbouard toe in) as opposed to the original "straight" 0 degree ones (A2210) that came on the first XX4 which had outbaord toe in (2.5 degrees)

okay thank alot guys :)