Roll bar width
 

This is an unusual request, but can someone check the width on their DEX410 rear roll bar please?

http://i103.photobucket.com/albums/m...lbaredited.jpg

I'm looking for one that has a width of 57mm or slightly more.

rear roll bar width
 

Approx 35mm ... I measured across from outside rear bulkhead roll bracket to the opposite side... the roll bars are a snug fit (haven't got an actual roll bar handy but from memory it's snug)

width same with yokomo touring kit roll bar size.........................:yawn:

Thanks! Did you mean the Yokomo bars were 35mm or 57mm in the centre?

I used it for my 410 ultra is 35mm for both-side front and rear respectively ............but the rear roll bar should be cut it off the end of roll bar edge for suitable length ...............:D

Can you not just go to your LHS, buy some rod and make your own?