Setting up 2.4ghz transmitter
 

Hello all,

Well I'm getting the 8.5T motor set up (ESC has a faulty fan but I am expecting them to replace that) however I am having issues with my CODE transmitter.

The steering does not seem to be recognised, and the throttle would appear to be always on.

I plugged an old 27mhz setup into it which is how I know it defaults at 100% forward, and the steering works fine.

The steering on this transmitter worked fine last week on my old brushed system - only thing I touched was the trim.

It is a CODE DSSS (using Code CR139 receiver)

Oh and I have also tried resetting the tx and re binding the rx. It worked properly for a brief moment, then went back to fail

Figured it out, I have to do a complete rebind each time. Switch the car or the tx off - and a full rebind is required.

Working as intended?

Something is wrong there buddy :thumbdown: They should hold the bind (mine holds the bind when I turn it off/on as do about 5 other people I know of with one, between us we've got a mixture of the old, grey Rx and new, blue Rx ones)

Anyone have any ideas why it may be doing this?