Fusion Exceed Pro/6.5T - cut out temperature
 

Quick question on this as my googling skills aren't up to it.

What is the cut out temp on this ESC? I've had a few glitches when the car refuses to move for a few seconds (its not low batteries, its not a short circuit, its not a glitch, its usually after running hard for almost a full battery, lots of standing starts sort of thing.

Just leaving it for a few seconds "fixes" the issue.

The motor is (pretty much) too hot to touch, as is the ESC heatsink. Haven't burnt myself on it yet tho :) I suspect its the thermal cut out.

Also, what units does the programming card show for temp? Motor? ESC? Centigrade? Fahrenheit?

Anyone?

I did have a similar issue with the same combo this summer while using the unit in my Durango. I fitted an ansmann fan on top which plugged into my receiver just to give the cooling a helping hand.

It worked.:thumbsup:

So i'd say, fit a fan.

Lol, that's what I did in the end! Works perfectly now.

(And in a Dex 410 too..... small world)

(may even have been an ansmann fan......)