servo saver tightness? and another set up question.
 

i was putting together the servo housing and i noticed it dose not say how tight to screw this


http://i481.photobucket.com/albums/r...IMG_4038-1.jpg

how tight should it be?

and one more question.




is this a good very low traction set up?
http://www.petitrc.com/setup/durango...ts20100416.pdf

but it seems to be mostly a stock set-up tho.

because the track i race on is a dirt/clay track with bits of gravel in some areas and is not kept at all so its very low traction.

It should be 1.4mm below the end of the sarvo saver shaft it's all on the Durango website http://www.team-durango.com/blog/?cat=3&paged=2

mine's about a thread from the end. I found the 1st night I ran the car it came loose and it's a little pig to remove in a hurry.

I drop of threadloc and no problems since. Just had to remove it to install the alu arm and no problems tonight

oh ok thanks :) never saw that page.

and what about the set-up dose that one look good?

The link doesnt work

I personally have taken the spring out and threadlocked it solid...

oh sorry about that here this one should work.
http://www.petitrc.com/setup/durango...ts20100416.pdf