Problem with 1/10th TC
 

Hi

I am posting this on behalf of a friend.

My friend is running an Xray TC with GM120 from 2009, with a 13.5T motor and lipos.

He has a problem with it. He will start the race with turbo then after a short time (this can range from 1 lap to 2mins) he will loose the turbo effect on the car and the car will become very flat when throttle is applied. The motor is not getting to hot. We had somebody at the club check the speedo settings and they seemed to be ok. We thought it was the servo causing the power loss but we changed it and it was still doing it.

Any advice would be helpful.

James

Sounds like a sensor wire to me

yes, either the sensor wire, the sensor port on the motor, long shot, drastic voltage drop to.

i had this on my xray t3 car changed sensor wire, sensor board on motor still made no difference was told on another rc forum to disable low lipo battery from 3.v per cell to off on the speedo this did the trick full speed for the full 5 mins hope this helps

Hi

Thanks for the advice guys.

We have tried changing a sensor wire. We took a sensor wire from another car which was working and still did the same thing.

Anything else we could try?

James