X2c and Mad Monkey stainless steel weight set
 

hey guys just a quick pole if i was to make x2c and mad monkey weights who would buy them i will be bringing out a few bits to improve the mid motor cars over the next few weeks

the x2c weights i have already and will post them up tonight :thumbsup:

How much would they be?

£14 posted for an under lipo and under electronics weight should weigh about 107 and 38 grams respectively

why not brass, it would weigh more?

It would weigh 9% more yes but it's a pig to machine and would mean it would be about £15 for the under lipo weight alone I will make brass but it would be about £25 for the both

under the lipo there in option on the Ansmann product.

not on the X2c also the ansmann one is steel plated in brass not really brass :cry:

I assume you know we already make under Lipo weights!!

www.rudebits.co.uk

Here they are!!!!
 

here we go people the long awaited photos:thumbsup: Andy Reeves is the first to buy them im sure he will let us all know how they go.

i assume people have seen that they cost £25 for just the under lipo weight !!! :wub im offering both for £14 and its only 4 grams lighter in stainless :wub

I'm actually not interested in under lipo weights, but rather something around the gearbox, something that is aft of the lipos. Is there a plan to do something around there?

I will sure have a look and get back to you

Steel T piece? or wishbone mounting blocks?

Lipo weights look good mate

Yeah pivot blocks maybe not the t as it's a complex pattern really and it would probably weigh close to 120g

+1 T piece with 2 separate mounting blocks ala rat style!

What material for the t plate though?

Depends of the amount of weight you would want to achieve. You also want the weight as low as possible.

As above really! :thumbsup:

Also the pivot blocks to accept the plastic pivot ball inserts as in these:
http://www.teamcracing.net/index.php...mart&Itemid=71

Is it just me who wouldn't want anymore weight on the back? :(

t-Piece would be a tricky thing to so as it has the gearbox mounted to it. Was easier on the rat as the gearbox wasn't bolted to it. I would like to see seperate block on the front though so we can change the anitsquat.

I am pretty sure the block you would need to make for the front is the same as the original rat one (I Measured this up before but can't remmeber which one I found was match now.)

Back to the weights, is it 14 pound per pair or 14 pounds each? and how do I order?

I've not got one so I don't know if this is possible, but when I had a Mardave cobra I used to put a couple of washers between the front gearbox and the chassis to raise it a bit, or give a greater degree of anti-squat.