Lipo charger over voltage error message?
 

What's going on? Is my lipo dead?

Lipo still about half charged after 1 heat, gone to recharge and get this error message?

All other lipos charge ok so guessing charger ok?

Plug lipo back in to car and runs sweet still?

Any ideas?

Charger error outs on all modes!

Using a Icharger 106b

Also tried it on an older charger I have and that too errors out!

Lipo is a trekpower gold 4900

Thanks for any help
Andy

Have you tried charging without balancing

Yep! Tried all settings! Just errors out!

lipo
 

Try discharging the lipo until usual cut off then try recharging from discharged state in unbalanced mode.

At the very least if your lipo will not recharge then it is in a 'safer' state for disposal.

Check the pack and cell voltages and then post back up with results.

Will run it down laters and see what happens!

Charger errors out so can't even see that?

A good investment would be a multi meter. Can get em for less than a tenner dlivered. In the mean time set your charger to nimh setting just so you can read the pack voltage. Just remember to stop the charge afterwards. Sounds like the pack is under voltage although you say it runs your car fine. If it is under voltage you would get fairly poor power.

Do you use the same charge lead for this pack as you do with the others. If you use a different charge lead you need to check that also.

where is your balance lead from? if its a core one I had the same problem and the balance lead plug is wired wrong try it with out the balance lead plugged in