How to adjust Antisquat on B4.1?
 

Hi,

I've read tons on what antisquat degree set up suits which track surface, but can't seem to find anything about how to actually alter it in the build manual!

I'm thinking you add washers or shims somewhere when you assemble the rear end, perhaps under the rear arm mount?

I'm probably missing something obvious, but any pointers greatly appreciated!

I am using the RTR version of the B4.1

on the B4 it was adding washers on the mount that holds the front of the rear wishbone pins

there should be plasic shims with pipps on 1,2,you undo the two screws on the front of the rear hinge pin holder,the shim has slots in to go around the screws so you dont need to take the screws out,

oh yeah my bad. it's the B44 that has washers :)

Thanks Guys,

I found this once I searched again using the word "shim".

http://www.jespares.com/electric-mod...tegory_id=1289

Looks like it comes with two thicknesses to run either or both for three options.

But I don't think you get these shims in the RTR version of the kit, as I don't seem to have any!

yeah thats the ones,if you have a rtr,have a look in the for sale section,im selling some b4 ft stuff and its got the shims in:thumbsup: