RPM Long Shank Heavy Duty 4-40 Rod Ends Will they fit?
 

As the titel says.. Will they fit on durango original Pivot ball's?

RPM Long Shank Heavy Duty 4-40 Rod Ends: http://www.jespares.com/electric-mod...word=ball+cups

Thanks you

//Jachto

No they won't unfortunately
Me and my mates are using edit tit ballstuds from hpi.com.uk the 13.5 mm ones as they are on special offer at the mo and are metric m3 but then take the losi /rpm ballcups
They work perfectly
No slop and you can even adjust them on the car with out them popping off! Luxury:thumbsup:
Hope this helps

HPI balls and Losi cups - perfect. End of...

Oh and that's xxx losi cups
Forgot that bit!

+1 :thumbsup:

HPI balls and Losi OR RPM ball cups. Either ball cup fits the HPI balls, and are equally as good as one another.

Losi cups are easier to get hold of - we have them in stock, HPI balls we really should get in stock!

I'm using Associated TC5 balls (yes, they are metric 3mm) and the RPM cups. The RPM cups fit very tightly and the joints no longer have any slop in them like the stock ones did.

Anybody got a link for these hpi ball studs? What are the ideals lengths for the 410?

Shumached ball stud and losi rod end fit perfict.

HPI balls even better :)

So i want to come to an end with this discussion :woot:
I want to use the RPMs Heavy Duty Road Ends (yellow :thumbsup: )
So i have to change the Durango Ball-studs (330035 & 330033)
In my understanding i need now HPI Ball Studs for the 330035
They are available in 9, 10.3 and 13 mm.
If i'm right i need the 13 mm (HPI 175116), correct?
But what is with 330033??:confused:

I wonder that too, what did you guys use?