Cat belt cover & alloy inner trans housing
 

Im after a belt cover to fit and xls/procat/bosscat, anyone know of anyone doing any repro ones ? Seen the shells but no belt covers that fit the top deck
Also after an alloy inner transmission housing if anyone has one knocking around that they fancy parting with ?
Thanks

Those belt covers are rare as rocking horse sh*t - I haven't seen any in... forever! :(

Also looking for one and if anyone find one send it to kamtec so it can be duplicated.

mvh Isobarik

dave, i`ve got a used one you can borrow as a pattern to get some made if you want. i also have an alloy inner housing that for some reason has had a hole cut in the front you can have.

Yes, they are very rare in good condition! I asked Team Bluegroove and they might be interested if they could get a new 'master' to work from. I'm happy with their Procat shell and undertray. Maybe someone would be willing to send them one?

Cover
 

I've not to long ago sold a xls top cover on eBay did not fetch as much as I thought it would of to be honest,but I might have a spair one in the shed will have a look tonight for you.

lovely thanks mate :thumbsup:

It's dead simple! It doesn't even need to be that spectacular as it's just to keep the transmission dirt/fluff free! I'd gladly make a mould out of wood or something if it's possible for Keith to make a mould from it!

I have got moulds of 3 different types of belt covers, so I can vacform some.
One is SWB CAT, the other 2 are for long wheelbase, one has that flat rectangle thingo near the front (I think this is for a CAT XL) the other is the same length but without the rectangular bit which I think is for the Procat?
Is Bosscat the same fitment aswell?

Put me down for one of the Procat belt covers please.

I'm sure there'll be plenty of demand... who can get these made?

Ta daaa found one just didnt remember that i got it....

http://proxy1.pixbox.se/arkivet/synl...30659041.jpg?0

since its not in my garage its at my parents house.

mvh isobarik

Cool can it be sent off for some repro ones ?

4 boys what if they break theire speedo at the same time...ha ha ha ....

I have 3 girls and 2 of those is sharing an RC10 Teamcar with an kyosho stock 05 in it ...

mvh isobarik

I.ll guess that it can be best would have been if it wasnt cut but i think it works and the finish is not so importante on an beltcover.

mvh Isobarik

Great... will you send it to TBG or Kamtec? I heard Kamtec takes forever.

The Procat shell I got from TBG is good. There's a photo in my thread Procat for Li-Fe.

[email protected]

Shall email him and ask.

mvh Isobarik

Deffo interested in a repro! Willing to contribute towards costs of getting these made too - even if it means underwriting the first x off the line!* :woot:

Does anybody remember what the flat bit was for? I keep thinking it's for sticking the driver to but I think it's too far forward for that!


* where x < 10 :p

How did you get on, Henrik?

btw he's got a sweet photo of my shell (paint by RCS) on his eBay listing...

http://cgi.ebay.co.uk/SCHUMACHER-PRO...item2305ade745

Simonl says Kamtec are making a mould for the belt cover :thumbsup:

Yeah i asked keith ?? and he had an mold but he was not sure that it was fitting right so he said that he would send me one to try but i havent recived it yet.

mvh isobarik