Ball studs
 

Hi all... Im wanting to fit my lunsford turnbuckles to my midrat, im using losi ball cups that are an imperial size so dont fit the standard ballstuds...

So my question being, are they any bull studs with a metric (3mm) thread, but a ball that fits the losi cups?? Im sure i heard schumacher ones will fit but i cud b wrong?

Cheers in advance! Tom

Hot bodies? I think?

Id heard that too, i need 2 Ti ones aswell for my shiny ally hubs :thumbsup:

also tc5 ball studs have 4.3mm ball with metric thread.

I use them on my durango

Edit do some to...

http://www.redrc.net/2008/01/edit-rc-titanium-ball-studs/

Well they used to. Just seen how old that post is :o

Any 4.3mm ball stud will work, I use either HB61582 4.3mm x 13mm or ED050030 titanium 4.3mm x13mm, these will fit RPM ball cups.

Do you stock these? If so id like to order a full set including 2 Ti ones for the rear hubs :thumbsup:

Tah, Tom

I got the Titanium versions in stock, they retail at £6.99 instead of the usual price of £9.99 for 2, send me a pm to sort, cheers Eric

low profile studs?
 

Hello, are there 4.3mm ball studs with a lower profile than the Schumacher ones, which are 6.3mm high? I have a clearance issue which a shorter stud might solve. Thank you.

http://i103.photobucket.com/albums/m...2535edited.jpg