alloy servo horns
 

so what alloy servo horn fits under the driveshaft?

got an answer rc one but far to long.

:thumbdown:

I am using the following and fits just fine.


http://www.amainhobbies.com/product_...-Hard-Anodized

I just got a Dynamite machined aluminum arm from MK Racing, not fitted it yet, but putting it side by side with a std one, it looks the same size, so should fit ok, cost about £3.50.

I got the Dynamite one from MK as well. Doesn't fit in my car. Had to dremel the top hole off and use the plastic top from the std horn as a spacer.

Haven't raced it yet but it seems to work.

But, the linkage is very close to the servo because you have to use the second hole from the top so depending on the shape/size of your servo case it might not work. Without some dremeling that is.

would rather a straight fit if poss.

The Racers Edge horn is a sttraight fit. No need for mods. I'll post a pic.

Ok super can you post a link to?

I use the Racers Edge Pro to remove flex and backlash. Great mod! Definate improvement!
The Pro works with my Ace 1313, and 1510, but may not work with some servo's. Each are a bit different.

Do you have a part No/ and is it the same size as the original or do you have to cut it down ?

No modifications.
RCE10380HA
Racers Edge Pro (Futaba)

Cheers dude :thumbsup:

just ordred one :D

3 servo horns stripped in a week :mad:

Is your track a real car breaker or something? I've only done 3 horns since I got the car in September '09.

na i like my servo saver screwed up, lesson learnt

Wow, what servo are you using?

Where are you getting your's from fella ( racers edge RCE10380HA ) can't find it anywhere ? :cry:

You guys won't be getting a reply - he's banned.

Anyway, most people I know use the Losi horn. ;)

G

The one off the CR, G ?

No, this one:

http://www.losipartshouse.com/servle...um-cln-/Detail

Or the correct one for your servo anyway.

Do you have to cut it down at all G ?