Originally Posted by soane (Post 454396)

This is my first brushless system that I have used and I've installed into my Ansmann Macnum and I've already run into problems. At the moment I'm running a 19t pinion and a no-brand 5000mAh Ni-Mh battery, if I accelerate with full throttle it will cut out but if I feather the throttle to full throttle it will run OK. These are the specs of the kit:

• Sensorless
• 60A continuous load
• Short-term exposure 300A
• 4-10 cells NiMH / 2-3 LiPo cells
• Forward / Reverse / Brake
• Reverse: soft 3 modes (soft, medium, aggressive)
• 3 accelerator modes: soft, medium, and aggressive
• Brake: 4 modes
• Overheating protection
• LiPo Low Voltage Protection
• Fans

Would I be right in thinking that the Ni-Mh isn't capable of keeping up with the demand of the controller? I fitted a 24t pinion and I cannot get full throttle at all. Would I be better changing the acceleration curve? :confused: