Mad rat shocks upgrade
 

Hi.

Bought a Mad Rat kit for Xmas and wish to gradually upgrade the car.

I have replaced all the bearings wirh ball race bearings and nowwish to upgrade and replace the plastic shocks.

I have read that you can interchange some shocks from other makes. What brands/ make?

looking for a set of 4 second hand or budget brand new if anyone wishes to sell theres.:D


James

You could go for Ansmann alloy shocks or Associated b4 alloy shocks. I use Losi xxx-cr shocks on mine (need to use the losi mount bushings though)

Add Tamiya TRF buggy shocks to the list - I was fortunate to get some here on Oople, but can be had on eBay for under £50.

Associated ones should be readily available for around £25 used (or new for a little bit more), best upgrade for those are the bleed caps at an extra £5 or £6.

As the biggest issue with the Madrat shocks are the tops popping off, you could try to find alloy shock bodies and alternative caps - not sure what will fit, though - perhaps changing pistons to match the shock body would be enough?

length of dampers
 

Thanks fro the quick response.

Just to clarify, the rears are 95mm between each mounting point and 75mm for the front? (measured it roughly with a compass on the car0

Modelsport have got the ali ones but come in 95 85 and 75mm so need to make sure i got the right sizes before I order.

These are the ones. Would you call these an upgrade? They dont have front (75mm) in stock though.

http://www.modelsport.co.uk/index.php?product_id=28324


I have seen these on ebay...

http://cgi.ebay.co.uk/ws/eBayISAPI.d...=p5197.c0.m619

Any good and will they fit?



James

Those Ansmann shocks are not the X Pro ones - they pre-date that car, and are not of the same standard. Unknown brand shocks off ebay are a pure lottery - probably a waste of money.

I'd not go for the ansmann alloy ones you show..they leak, I got a set to try them as they were so cheap...but they really are 'cheap'.

I'm running Traxxas Bandit alloy, teflon coated shocks atm, set of 4 for £54..very tough and smooth running shocks,not threaded.

J

I have a set of the alloy Ansmann shocks linked and they are fine

I'm runnig 75mm fronts and 95 rear on both my X2 and my X2c

with the X2C I'm runnig 40w front and 25 rear, pistons drilled to 3 hole 1.2mm all round
with 2mm front limiting on outside and 4mm limiting on outside of rear ( no inside limiting )

Ive also drilled a new inner hole on the rear tower and bone for tunnig options for when I run a rear roll bar

Ill post a full set up asap

JP
i may be able to help you out with some shox if needed
Check your PM ;)